带攻角约束的高超声速飞行器自适应反步控制器设计

针对带攻角(AOA)约束的高超声速飞行器控制问题，提出一种基于非对称时变障碍函数的非线性自适应反步控制方法。首先，将飞行器模型化为严反馈形式，以反步法为基础进行控制器设计。然后通过光滑饱和函数对名义攻角指令信号进行限幅，并保证限幅信号的可导性，限幅产生的误差通过设计辅助系统进行补偿。进而使用障碍函数对攻角指令跟踪误差进行非对称时变约束。针对不确定性和干扰，设计新型自适应律对集中干扰上界进行估计并补偿。最终通过Lyapunov理论证明了闭环系统状态量一致最终有界并且攻角始终满足时变约束。仿真结果表明，本文方法能够在满足攻角约束基础上保证良好跟踪性能。     

Six sigma robust design optimization for thermal protection system of hypersonic vehicles based on successive response surface method

Lightweight design is important for the Thermal Protection System(TPS) of hypersonic vehicles in that it protects the inner structure from severe heating environment. However, due to the existence of uncertainties in material properties and geometry, it is imperative to incorporate uncertainty analysis into the design optimization to obtain reliable results. In this paper, a six sigma robust design optimization based on Successive Response Surface Method(SRSM) is established for the TPS to improve the reliability and robustness with considering the uncertainties. The uncertain parameters related to material properties and thicknesses of insulation layers are considered and characterized by random variables following normal distributions. By employing SRSM, the values of objective function and constraints are approximated by the response surfaces to reduce computational cost. The optimization is an iterative process with response surfaces updating to find the true optimal solution. The optimization of the nose cone of hypersonic vehicle cabin is provided as an example to illustrate the feasibility and effectiveness of the proposed method.     

场协同原理在高超声速化学非平衡流动中的推广

应用理论分析与数值模拟方法，将对流传热的场协同原理从不可压缩流动推广至高超声速化学非平衡流动中。结果表明，高超声速化学非平衡层流与湍流的热流密度取决于流动的当地单位体积的动量与单位质量总焓梯度的协同。用当地单位体积的动量与单位质量总焓梯度的协同研究高超声速化学非平衡流动的壁面传热问题，对层流流动下的对流传热，不但计及了高超声速化学非平衡流的密度变化对热流密度的影响，而且包括了静焓梯度、压力梯度、边界层内的分子黏性剪切效应对热流密度的作用；对湍流问题，除了上述层流流动各项对热流密度的影响外，还计及了雷诺剪切应力对热流密度的作用。考虑到高超声速化学非平衡流静焓的定义，高超声速化学非平衡层流及湍流的场协同同时计及所有组分的平动能、转动能、振动能及电子能等梯度的贡献。     

拦截高速目标的比例与反比例导引捕获区分析

针对拦截高速目标的作战特点，分析了比例导引(PN)与反比例导引(RPN)的捕获区。首先，通过分析拦截弹与目标的相对运动关系，推导得到了顺轨和逆轨的零控拦截条件，此条件由目标和拦截弹的速度前置角以及二者速度比确定；其次，以拦截弹和目标速度前置角为坐标系，推导得到了PN以及RPN捕获区以及各自导航比设置范围。PN的捕获区由逆轨零控拦截条件以及与其相切且斜率为1/(N-1)的两条直线构成，RPN的捕获区由顺轨零控拦截条件以及与其相切且斜率为1/(-N-1)的两条直线构成；然后，利用函数对称性将PN与RPN捕获区转换到同一坐标区间，得到了相同条件下RPN捕获区要大于PN捕获区的结论；最后，开展了四种情形下的仿真，验证了本文捕获区分析的合理性及有效性。     

Numerical analysis of hypersonic thermochemical non-equilibrium environment for an entry configuration in ionized flow

A theoretical methodology for thermochemical non-equilibrium flow combing with the HLLC (Harten-Lax-van Leer Contact) scheme was applied to study the hypersonic thermochemical non-equilibrium environment of an entry configuration in ionized flow. A two-temperature controlling model was utilized and the Gupta’s 11 species (N₂, O₂, NO, O, N, NO⁺, N₂⁺, O₂⁺, N⁺, O⁺, e^?) thermochemical non-equilibrium model was taken. Firstly, numerical calculations of hypersonic thermochemical non-equilibrium environments for different aerodynamic shapes were carried out to verify the reliability of the method above. Then, the method was used to research the effects of ionization and wall catalysis on the hypersonic thermochemical non-equilibrium environment of the entry configuration in ionized flow. The shock stand-off distance can be reduced by thermochemical reactions but doesn’t continue to decrease significantly when ionization occurs. The shock stand-off distance calculated by the 11 species model is 4.2% smaller than that calculated by the 5 species (N₂, O₂, NO, O, N) thermochemical non-equilibrium model without considering ionization. Ionization reduces wall heat flux but increases wall pressure a little. The effect of ionization on aerothermal loads is greater than that of aerodynamic loads. The thermochemical reactions of electrons and ions catalyzed at the wall increase wall heat flux significantly but make a small change in wall pressure. The maximum wall heat flux obtained by only considering the electrons and ions catalyzed at the partially catalytic wall condition is 11.8% less than that calculated at the super-catalytic wall condition.     

带轴对称台阶的圆锥高超声速边界层转捩试验

在Ma 6风洞内，通过高频脉动压力测试技术和基于纳米粒子示踪的平面激光散射(NPLS)技术，分别对带前向、后向轴对称台阶的圆锥高超声速边界层转捩进行了试验研究。采用功率谱密度分析和互相关计算等方法对脉动压力数据进行分析，得到了边界层中扰动波的发展规律，定量分析了第二模态波的相关参数。结果显示：两种模型中第二模态波在沿流向向下游发展的过程中，其幅值均先增大再衰减、特征频率均逐渐减小；特征频率和传播速度整体上均随雷诺数的增大而增加(后台阶模型中特征频率由100 kHz增至196 kHz，前台阶中则由 97 kHz 增至174 kHz)、波长变化规律则与之相反(后台阶中由6.35 mm降至4.54 mm，前台阶由7.35 mm降至 4.66 mm )；后台阶模型中第二模态波初次出现位置比前台阶中更靠近上游，边界层转捩位置较前台阶前移。将NPLS结果与高频脉动压力测试结果进行对比，两者吻合较好。     

谱估计理论在弹道数据参数化建模中的应用

针对高超声速飞行器防御作战中目标运动规律的描述问题，提出一种基于经典和现代谱估计理论的弹道数据参数化分析和建模方法。该方法将弹道数据视作非平稳随机信号，研究其变化规律：首先，通过线性消势法消除信号的线性趋势，将其转变为平稳信号，以便于进行谱估计；然后，采用Welch算法给出大致的谱图，结合该谱图和改进的协方差法确定自回归参数模型的阶数，以避免模型阶数选择准则引起的不确定性问题；最终，给出弹道数据的参数化模型。仿真结果表明，使用本文算法建立的弹道数据参数化模型与动力学模型具有较高的一 致性。     

WSO-UV project

During last three decades, astronomers have enjoyed continuous access to the 100–300 nm ultraviolet (UV) spectral range where the resonance transitions of the most abundant atoms and ions (at temperatures between 3000 and 300 000 K) reside. This UV range is not accessible from ground-based facilities. The successful International Ultraviolet Explorer (IUE) observatory, the Russian ASTRON mission and successor instruments such as the Galaxy Evolution Explorer (GALEX) mission or the COS and STIS spectrographs on-board the Hubble Space Telescope (HST) prove the major impact of observations in the UV wavelength range in modern astronomy. Future access to space-based observatories is expected to be very limited. For the next decade, the post-HST era, the World Space Observatory – Ultraviolet (WSO–UV) will be the only 2-m class UV telescope with capabilities similar to the HST. WSO–UV will be equipped with instruments for imaging and spectroscopy and it will be a facility dedicated, full-time, to UV astronomy. In this article, we briefly outline the current status of the WSO–UV mission and the science management plan.     

多飞行器再入段时间协同弹道规划方法

提出了一种多飞行器再入段时间协同弹道规划方法。首先,在纵向平面内规划满足航程与终端约束的纵向标称轨迹。随后,在采用轨迹跟踪律跟踪纵向标称轨迹的同时,运用考虑初始横侧向状态的多边界航向偏差角走廊策略控制飞行器的横侧向机动,以满足到达时间约束与终端约束,进而实现单枚飞行器到达时间约束下的轨迹规划。在此基础上,完成了飞行器的到达时间分布与飞行能力分析,给出了最小与最大到达时间的分析计算方法,并根据多飞行器协同再入的任务需求完成了协同飞行时间决策。最后,多飞行器协同再入与扰动条件下的仿真结果表明,该方法能够规划出满足到达时间与终端约束的协同再入轨迹,具备良好的计算精度与鲁棒性。     

有翼再入飞行器气动外形集成设计优化

气动外形设计是有翼再入飞行器（RV-W）的关键技术之一。分析了气动参数对再入飞行性能的影响,探讨了有翼再入飞行器气动外形设计的规律和准则。基于上述设计准则,以类X-37B飞行器为研究对象,集成几何参数化建模、气动力、气动热、热防护等学科快速分析方法,采用多学科设计优化方法,以最优气动特性为目标对飞行器气动外形进行了优化;得到优化气动外形后,对飞行器热防护系统（TPS）进行了轻量化设计优化。结果表明,优化外形的气动特性相比初始外形得到了较大的提升,设计优化得到的热防护系统重量占比（8.7%）优于同类飞行器的热防护系统重量占比统计数据,说明了本文有翼再入飞行器气动外形集成设计优化方法的有效性,可为同类飞行器提供参考。